Planar Systems PT2245PW Guia do Utilizador descarregar pdf (Página 10)

Connecting the Display (Figure 8.1)

To setup this display, please refer to the following gure and procedures.

1. Be sure all equipment is turned off.

2. Connect the DC plug to the power connector on the monitor and the other end into an

electrical outlet (8.1).

3. Connect the D-SUB or DVI cable from the display’s D-SUB or DVI input connector to the

D-SUB or DVI connector of your host computer and tighten the screws (8.1).

4. Connect the USB cable from the USB port of your display to the USB port (8.1) of your

computer.

5. Congure the touch screen. Refer to the “Touch Screen Driver Installation” section on

page 17.

6. Once the touch screen is congured, the monitor is ready for use.

Notice!

To ensure the display works well with your computer, please congure the display

mode of your graphics card to make it less than or equal to 1920 x 1080 resolution

and make sure the timing of the display mode is compatible with the LCD display.

We have listed the compatible “Video Modes” of your LCD display in the appendix

(on page 16) for your reference.

Applicable external power supply: Lite-On/PA-1051-0

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sem comentários

Planar Systems PT2245PW Guia do Utilizador Página 10